Gared Pro-S Portable Backstop
10
18.
Slide the locking collar on the leveling screw down to contact the leveling screw plate
and secure with the set screw. The locking collar is used to insure the leveling pads are
always set at the correct height when the unit is moved or reinstalled.
19.
To level the backboard in the horizontal plane, loosen the four ½” bolts and the one ¾”
bolt in the center of the Quick Change Bracket attached to the boom. Refer to figure 10.
Level the board and tighten all bolts securely.
Figure 10
20.
To level the backboard in the vertical plane, loosen the two carriage bolts at the board
brace clamp on top of the boom. Refer to Figure 11. Using a ¾” wrench, adjust the
leveling bolt in the board mounting bracket until the backboard is plumb. Tighten the
locking nuts on the leveling bolt. Tighten the two carriage bolts at the brace clamp and
the two carriage bolts at each corner bracket securely.
Figure 11
20.
Attach plumb bobs to the front corners of the backboard. Plumb bobs should hang down
from the corners to where they are almost touching the floor.
21.
Check plumb bobs with marks that were located in step 13. If the plumb bobs do not line
up exactly with the marks on the floor, adjust the location of the unit accordingly.
3/4” Bolt
1/2” Bolt
1/2” Bolt
