Gared Pro-S Portable Backstop
6
INSTALLATION INSTRUCTIONS
Tools Required:
Adjustable wrench with 1-1/8” to 1-12’ capacity
½” wrench and socket
9/16” wrench and socket
¾” wrench
#2 Phillips screw driver
Flat blade screw driver
Allen wrench set
Two plumb bobs with string
Bubble type level
Tape measure
Hand drill
1” spade bit
¾” drill bit
Masking tape
Pencil
See Installation Instruction for Rear Floor Insert (item 33) for additional tools.
Item numbers noted throughout these instructions refer to the parts listed in the parts check list
on page 4.
Unpack all parts and check for damage or missing items.
1.
Install a 1” Shaft Collar (item 18) onto each Stabilizer screw (item 14). Slide the shaft
collar up to the Nut at the top of the stabilizer screw and loosely tighten the set screw to
keep the collar from sliding during assembly.
2.
Install the Stabilizer screws (item 14) into the frame as shown in figure 1. Adjust the
stabilizer screw with about 1” to 1-1/2” of the screw extended below the frame brackets.
Figure 1
3.
Apply Loctite
®
to the threads of the leveling pads (item 15) and attach the leveling pads
to the stabilizer screw rod. Turn the nut on the leveling pad with a 1-3/8” wrench or an
adjustable wrench until tight.
4.
Use the ratchet and 1-1/2” socket supplied and lower the leveling pads to lift the front
casters about ¼” off the floor. Make sure the unit is raised evenly.
Frame
Item 18
Item 14
Item 15
