![background image](http://html1.mh-extra.com/html/gardner-denver/pureair-ewd99e/pureair-ewd99e_operating-and-service-manual_3861293027.webp)
13-11-608 Page 22
Remaining blowdown and auto times are only available in Low Demand, Automatic, and Sequence
modes, as appropriate.
If no keys are pressed for 5 seconds, the display will revert to its normal mode.
The display is also used as a service reminder for normal maintenance items. If service is recommended,
the yellow LED next to the service symbol will come on, and a message will alternate with the normal
lower line message. These messages are intended to advise of conditions which may lead to a
shutdown.
If a protective shutdown occurs, the red LED next to the shutdown symbol will be on and the top line of
the display will indicate “SHUTDOWN.” The lower line will indicate the cause of the shutdown.
Figure 4-1 – AUTO SENTRY W CONTROLLER DISPLAY
SERVICE ADVISORIES
The AUTO SENTRY W controller turns on an advisory when it detects operation which needs service
attention, but does not warrant shutting down the compressor. Some of these are normal maintenance
procedures, and are intended to serve as a reminder to perform routine service. Others are conditions
which can reduce the maximum compressor performance. It will remain in effect until reset. Check the
display during routine inspections, and perform maintenance as suggested. Refer to the troubleshooting
section for detailed information about each advisory.
Temperature advisories may be cleared while the unit is running by simply pressing the [ENTER] key. To
reset the service advisories, press the [STOP/RESET] key to stop operation of the compressor. After it
has stopped, disconnect power and service as required. After servicing, restore power and reset the
controller as indicated in the programming / maintenance section below.
Summary of Contents for PUREAIR EWD99E
