![background image](http://html1.mh-extra.com/html/gardner-denver/pureair-ewc99c/pureair-ewc99c_operating-and-service-manual_3860178042.webp)
13-11-607 Page 37
SECTION 5
LUBRICATION
COMPRESSOR OIL SYSTEM
- The airend oil reservoir is filled with oil and the inlet bearing lubrication
fittings are greased at the factory before shipment. A tag on the reservoir fill cap indicates the type of oil
in the reservoir as it left the factory.
RECOMMENDED LUBRICANT
- Gardner Denver compressors are factory filled with AEON™
lubricants. These lubricants are formulated to the highest quality standards and are factory authorized,
tested and approved for use in rotary screw compressors.
AEON lubricants are available through your authorized Gardner Denver compressor distributor.
OIL SPECIFICATIONS
- The airend reservoir is factory filled with AEON 800 lubricant. A lubricant
analysis program for a periodic check of lubricant quality and remaining life can maximize the change
interval.
For grease specifications, refer to “Electric Motor Grease Specifications,” page 11.
Material Safety Data Sheets (MSDS) are available for all AEON lubricants from your authorized Gardner
Denver distributor or by calling 217-222-5400.
CAUTION
Use of improper lubricants will cause damage to equipment. Do not mix
different types of lubricants or use inferior lubricants.
CAUTION
Improper equipment maintenance with use of synthetic lubricants will damage
equipment. Oil change intervals must be adhered to for maximum compressor
protection and efficiency. See “Maintenance Schedule”, page 50
WARNING
High temperature operation can cause damage to equipment or personal injury.
Do not repeatedly restart the unit after high temperature stops the operation.
Find and correct the malfunction before resuming operation.
Summary of Contents for PUREAIR EWC99C
