![background image](http://html1.mh-extra.com/html/gardner-denver/l110-10a-v4/l110-10a-v4_translation-of-the-original-operating-instructions_563811059.webp)
9
APPENDIX
9.1
Shutdown
Routine shutdown
Routine shutdowns are for example shutdowns for
maintenance work.
1. Switch main switch OFF and secure to prevent
switching back on.
2. Close the shut-off valves between the com-
pressor and compressed air network.
3. Depressurise the aftercooler by careful opening
of the air vent valve.
Shutdown for a longer period
For shutdowns longer than six months, contact
Gardner Denver.
Final shutdown
To prevent restarting of the compressor or misuse
by unknown parties, the compressor must be ren-
dered unusable.
The compressor is rendered unusable by removal
of the electronic control unit. Contact Gardner
Denver for advice.
9.2
Lubricants and additives
The compressor contains approximately 54 l of oil.
The drive motor lubricator contains two grease
cartridges.
Safety data sheets
When handling operating fluids and additives, the
corresponding safety data sheets must be ob-
served.
Lubricating oil: FLUIDFORCE SCREW WAR-
RANTY LUBRICANT
Lubricating grease: MOBIL POLYREX EM
9.3
Removal
WARNING
Harmful to health
Risk of damage to health due to operat-
ing fluids and additives
Lubricants and additives may cause ir-
reparable damage to the health, trigger
allergies or irritate the mucous mem-
brane.
➯
When handling lubricants and ad-
ditives, always observe the locally
valid operating instructions/haz-
ardous substance data sheets.
➯
Avoid direct contact with lubricants
and additives. Wear personal pro-
tective equipment!
➯
Where injuries occur in which lubri-
cants and additives are involved,
consult a doctor and name the sub-
stances involved.
Have the hazardous substance data
sheet readily available.
CAUTION
Risk of slipping
Risk of slipping due to escaped operat-
ing fluid
➯
Immediately clear up any operating
fluid that has escaped.
➯
Avoid direct contact with operat-
ing fluids. Wear personal protective
equipment!
Preconditions
The compressor is out of service.
– The compressor is switched to a zero volts
state.
– The main switch is switched to OFF and se-
cured to prevent switching back on.
– The compressor is depressurised.
– Liquids and grease are as far as possible
removed.
Summary of Contents for L110 10A V4
Page 73: ......