3-1-618 Page iv
INDEX
Crankshaft Assembly .................................. 26
Crosshead Assembly ….............................. 24
Crosshead Guide and Tie Rods ….............. 25
Daily Routine Maintenance Schedule.......... 19
DANGER NOTICES, SECTION 1................. 1
Covers and Guards............................... 2
Equipment Moving and Lifting............... 2
Flammable, Hot, Cold or Corrosive
Fluid Pumping............................... 5
Hammer Lug Fasteners……………….. . 1
High Pressure Liquid Jetting,
Blasting and Cleaning ................... 6
Pressurized Pump Systems .................. 3
Valve Seat Pulling ................................ 2
DESIGN DESCRIPTION AND
SPECIFICATIONS, SECTION 2 ........... 9
Fluid End Description.................................. 13
Fluid End Removal and Installation ............ 21
Fluid End Service ....................................... 21
Foreword …………………………………..…. ..ii
Gear Reduction Unit ...............................11,26
General Requirements and Safety Rules .... 21
General Specifications................................ 14
Introduction................................................... 9
Lube Pump Suction Piping Sizing and
Requirements ..................................... 16
Lube System Pump .................................... 16
Lubrication, Plunger / Packing .................... 17
Monthly Routine Maintenance Schedule ..... 19
Oil Stop Head Seal Retainer and Crosshead
Guide End Plate ................................. 24
Ordering Instructions, Repair Parts ................ i
Performance Rating....................................... 14
Periodic Routine Maintenance Schedule........ 18
Plunger / Packing Lubrication ........................ 17
Plunger Packing Lubrication Recommendation
Chart ....................................................... 20
Plungers and Packing Replacement .............. 22
Power End.................................................10,24
Power End and Gear Reduction
Unit Lube System .................................... 12
Power End Lubrication System ...................... 16
Preparation after Shipping and Storage ......... 15
PREPARATION, OPERATION AND
MAINTENANCE, SECTION 3.................. 15
Pump Design................................................. 10
Pump Mounting Instructions........................... 15
Quarterly Routine Maintenance Schedule ...... 19
Rebuilding Data ............................................. 34
REBUILDING DATA, RECOMMENDED
RUNNING CLEARANCES AND
TORQUES, SECTION 6.......................... 34
Recommended Running Clearances – Actual 34
Repair Parts, Ordering Instructions ................... i
SERVICE PROCEDURES, SECTION 4 ........ 21
Specifications, General.................................. 14
Startup and New Pump Run-In Procedure ..... 17
Torques ......................................................... 35
TROUBLE-SHOOTING, SECTION 5............. 28
Warranty ................................................ Last Page
Valve and Seat Replacement ........................ 22
