![background image](http://html1.mh-extra.com/html/gardner-denver/electra-saver-ii/electra-saver-ii_operating-and-service-manual_3661013021.webp)
13–9/10–641 Page 12
AFTERCOOLER (DOMESTIC)
Approx.
Water Temperature to Heat Exchanger
Water Pressure
Gallons/minute
Maximum
Drop @ 90
_
F
Water Flow
Water Temp.
HP
Model
60
_
F.
70
_
F.
80
_
F.
90
_
F.
GPM*
PSI
40 HP
EBHSH_
.5
.7
.9
1.3
26.0
50 HP
EBHSJ_
.7
.9
1.2
1.8
26.0
60 HP
EBMSK_
.8
1.0
1.4
2.1
26.0
75 HP
EBMSL_
1.2
1.5
2.0
3.0
26.0
100 HP
EBPSM_
1.7
2.1
2.8
4.1
26.0
100 HP
EAPSM_
1.7
2.1
2.8
4.1
26.0
FIGURE 2–6 – AFTERCOOLER APPROXIMATE WATER FLOW
AFTERCOOLER (INTERNATIONAL)
Water Temperature to Heat Exchanger
Approx.
Liters/Second
Maximum
Water Press. Drop
Water Flow
@ 32
_
C. Water
KW
Model
16
_
C.
21
_
C.
27
_
C.
32
_
C.
L/S *
Temp. Bar
45 KW
EBMSK_
.05
.06
.09
.13
1.64
55 KW
EBMSL_
.08
.09
.13
.19
1.64
75 KW
EBMSM_
.11
.13
.18
.26
1.64
* Flows exceeding “Maximum Water Flow” will cause severe erosion and will void unit warranty.
Less than .1 Bar
for any flow rate
shown in the table.
Less than 1 PSI
for any flow rate
shown in the table.
Accessibility for inlet air filter servicing must be consid-
ered when relocating the filters from the unit to a remote
location.
DISCHARGE SERVICE LINE – The discharge service
line connection on both water–cooled and air–cooled
units is made at the right hand corner of the unit, viewed
from the opposite end from control panel side. When
manifolding two or more rotary screw units on the same
line, each unit is isolated by the check valve in the unit
discharge line. If a rotary screw unit is manifolded to
another compressor, be sure the other compressor has
a check valve in the line between the machine and the
manifold. If a rotary screw and a reciprocating com-
pressor are manifolded together, an air receiver must
be located between the two units.
Discharge air used for breathing will
cause severe injury or death.
Consult filtration specialists for addi-
tional filtration and treatment equip-
ment to meet health and safety stan-
dards.
BLOWDOWN VALVE PIPING – The blowdown valve
is fitted with a muffler for operation indoors. If the instal-
lation requires, the muffler may be removed and the