Gardeo GMTBT50HP55BS, Manual

Page: 51 / 63

ASSEMBLY
Following the assembly directions below, you
will assemble the front tine tiller in a few
minutes.
Wheels
Slide the tube sleeve into the wheels. Mount
the wheels on both sides of the bracket with
M10 flange screws, washers and flange nuts.
Attach the wheel covers.
Lower handles
1. Remove the M8X260 screw, flat washer and
lock nut from the rear end of tiller chassis.
2. Mounting holes for adjustment knob are
arranged in the top portion of each lower
handle.
Make sure the 3-hole side of the handle is
facing inward. Insert the bottom portions of the
lower handles into the mounting channels
located in the underside of each side of the
tiller chassis.
3. Mount the flat washer on the M8X260 screw
removed. Line up the holes in the bracket,
handles and tiller chassis. Slide the screw
through the holes from one side, then lock nut
from the other side. Leave them untightened
at this time.
4. On each side, slide on a M8X45 flange
screw
through the holes in the mounting channel and
the lower handle, then screw a flange nut.
5. Tighten down all the screws.
Tine shield extensions
Attach the tine shiel d extensions to the tine
shield with M5X12 screws and flange nuts.
Tilling tines
Place tilling tines on the tine shaft on both
sides of the gear box. Line up the holes in the
tine frame sleeves and tine shaft. Insert
O10X50 clevis pins through the holes in tine
frames and tine shaft.
Insert O2.5 cotter pins through the holes in the
clevis pins to secure them.