Gardenline GLPT 2538, User Manual

Page: 22 / 29

AFTER SALES SUPPORT
0151 649 1500 1890 946244 www.einhell.co.uk
43
25cc Petrol Grass Trimmer – GLPT 2538 Maintenance and servicing
AFTER SALES SUPPORT
0151 649 1500 1890 946244 www.einhell.co.uk
42
25cc Petrol Grass Trimmer – GLPT 2538 Maintenance and servicing
2. Remove the spool (Fig. 6c/Item H) and the spring (Fig. 6c/Item I) from the spindle
(Fig. 6c/Item J). The following steps only have to be carried out if only the line and
not the entire spool requires replacing:
– Remove the remaining cutting line from the spool.
– Hold the two halves of a new cutting line together in the middle and place the
loop in one of the slots on the spool divider (Fig. 6d).
– Wind the line with tension in a counter-clockwise direction as shown in the
illustration (Fig. 6e), with the two halves being separated by the spool divider.
Wind up all of the line down to the last 15 cm of each end.
3. Fasten each of the ends of the line in a slot (Fig. 6f/Item L) on the opposite side
of the spool.
4. Fit the springs on the inside of the spool and thread each of the ends of the line
through one of the eyelets in the spool holder (Fig. 6c/Item K).
5. Insert the spool in the spool holder. Make sure that the spring slides over the spindle
and does not get stuck.
6. Press the spool into the spool holder with your hand and use your other hand
to fasten the retainer screw tightly (Fig. 6g).
7. Give each end of the line a strong tug to pull the line out of the slots.
8. Cut off all excess line to reduce it to approx. 13 cm. This will reduce the load on the
engine when starting up and warming up.
Maintenance and ordering of spare parts
Always switch off the equipment and disconnect the spark plug boot (23) before carrying
out any maintenance work.
Fig.6g
Fig.6e
Fig.6d
Fig.6f
L L
Fig.6c
H
K
K
J
I