Gardenline CBC36A, Original Instructions Manual

Page: 34 / 56

31
2 X 20V Li-ion 5-in-1 Cordless Garden Kit
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL No.: CBC36A • 10/2020 • 702316
(toll free)
AFTER SALES SUPPORT
(toll free)
2 X 20V Li-ion 5-in-1 Cordless Garden Kit
e-mail: info.aldi@positecgroup.com 1300 889 028
MODEL No.: CBC36A • 10/2020 • 702316
the line trimmer spool (9). The line trimmer spool (9) of this device allows
the operator to release more cutting line without stopping the motor.
Accelerate the line to the maximum speed and tap the bump knob (52) on
the underside of the line trimmer spool (9) on the ground while operating
the trimmer. (Fig. M1)
Adjusting cutting line width
The trimmer head allows the operator to release
more cutting line without stopping the motor. As
line becomes frayed or worn, additional line can be
released by lightly tapping the bump knob (52) on
the ground while operating the trimmer.
NOTE: Line release will become more difficult if the
cutting knife (16) becomes too dull.
NOTE:
The original cutting width is 330mm. There
are two kinds of cutting width. When the cutting
knife (16) is mounted on the location as Fig. M2, the
cutting width is 330mm. When the cutting knife (16)
is mounted on the location as Fig. M3, the cutting
width is 380mm.
Change the cutting width as follows:
1) Turn off the device and wait for the device to stop
completely.
2) Remove the battery packs.
3) Loosen the cutting knife (16) from the inside of the clip-on line trimmer
guard attachment (15) by removing the 2 x screws with the wrench
(screwdriver part) provided, in an anti-clockwise direction.
4) Screw the cutting knife (16) back into the desired position. You have now
successfully set the position of the cutting knife (16).
Using the brush cutter
WARNING. To cut wild growth and scrub, lower the cutting head
down onto the growth to achieve a chopping effect. Use the
brush cutter like a scythe (sweep it to the right and left) at ground level.
M2
M3