47.1cc Petrol Chainsaw
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №. 61705 • 08/2018 • FCS4800A
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1800 909 909
47.1cc Petrol Chainsaw
MODEL: №. 61705 • 08/2018 • FCS4800A
12
13
This chainsaw comes fully assembled in the box and does not require any
pre-assembly.
Replacing/Re-Installing the Guide Bar & Chain
WARNING: The chain has sharp edges.
Use work gloves for safety.
WARNING: Ensure the engine is switched off when making any
adjustments to the chain and bar.
IMPORTANT: The front guard / chain brake (13) must be disengaged
when replacing / reinstalling the guide bar (19) and/or chain (20).
1. Place the chainsaw on a flat and secure
surface and check that the chain brake (13) is
disengaged (Fig A).
2. Remove the chain drive side cover (23) by using
the combination tool (bar nut tube spanner)
(32) in an anti-clockwise direction to loosen
the chain drive side cover nuts (24). (Fig B), and
then remove the chain drive side cover (23).
Ensure the chain brake (13) is NOT engaged.
3. With the chainsaw on its side and the bar uppermost, (Fig C), push the
guide bar (19) towards the drive sprocket (29) (Fig D), which will result in
the chain (20) loosening around the guide bar (19).
4. Remove the chain (20) from the guide bar (19) starting at the nose of the
guide bar first. Once the chain (20) is removed from the guide bar (19),
the slack chain can be removed off the main drive sprocket and lifted over
the brake and clutch assembly (22). The guide bar (19) is then removed
by sliding it away from the chainsaw housing and then lifting the bar over
the two threaded studs. When the bar is removed from the chainsaw it
should be thoroughly cleaned of sawdust and oil prior to reassembly.
5. Insert the guide bar (19) into position over the 2 threaded studs, and on
a slight angle upwards, and push the guide bar (19) under the clutch and
brake assembly (22) fully towards the drive sprocket (29) to easily place
the chain (20) around the guide bar (19) (Fig E).
6. Place the new chain over and then under the chain brake and clutch
assembly (22), and then around the drive sprocket (29) loosely with the
chain links in the direction shown on the guide bar (19) (Fig F).
Important Information
Assembly
A.
BRAKE
OFF
Assembly
IMPORTANT INFORMATION
B.
D.
C.
LOOSEN
FLAT
NOTE: SIDE VIEW
E.
F .
This chainsaw uses a 4 stroke engine and does not require the
mixing of oil with the fuel.
The chainsaw is fitted with ONE oil tank which supplies oil to
BOTH the engine and also the chain and bar.
4 Stroke Engine oil is required to be added to the combination oil
tank (6) on this chainsaw.
ALWAYS fill the combination oil tank (6) with 4 stroke oil every
time fuel is added to the fuel tank (8).
