Understanding and using these operating instructions
31cc Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
(toll free)
14
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
31cc Brushcutter / Line Trimmer
e-mail: [email protected]
1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
User Instructions
General Assembly for use as a
Line Trimmer or Brushcutter
Connecting the Lower shaft
to the Upper shaft
1. Lay the unit down so that the fuel tank
bracket (38) is resting on a secure surface,
or on the ground.
2. Loosen the shaft locking knob (14). (Fig. E)
3. Whilst pushing down on the shaft locating lever
(13) as indicated by the word “PUSH”, insert the
lower shaft (15) into the upper shaft (11) joiner.
There is a small locating slot in the lower shaft.
When this slot enters the joiner, release the
locating lever (13). Continue to insert fully the
lower shaft. When fully inserted the tab on the
locating lever (13) should locate into the slot of
the lower shaft. If the shaft slot does not locate
into the locating lever tab, rotate the lower
shaft until the slot fully engages. You will hear a
click when it engages. (Fig. F)
NOTE:
Ensure you check that the lower shaft
cannot be pulled outwards when the lever is
correctly engaged.
4. When the shaft is located, tighten the shaft
locking knob (14) to secure both shafts in place.
(Fig. G)
5. Using the 5mm supplied allen key (36), check
the screw on the underside / opposite side of
the locking lever is tight. (Fig. H)
E.
F.
G.
H.
