Metal raised bed
51in x 51in
51in x 23.6in
98.4in x 23.6in
BRACE
27.5in
27.5in
27.5in
27.5in
27.5in
27.5in
23.6in
23.6in
19.7in
19.7in
19.7in
19.7in
19.7in
19.7in
• Before assembly and while
unpacking, please be aware
that there are sharp corners and
edges that could cause injury and
it is advisable to wear protective
gloves when handling these
items, sensible shoes are also
recommended. Until such time
as the SAFETY EDGE is fitted all
necessary precautions need to
be undertaken to avoid injury.
• We recommend placing the
bottom edge of the bed on a
layer of 1/2 - 3/4 inches gravel,
this allows excellent drainage
and protects the bottom edge of
the bed. Placing the bed on level
ground is also advised.
• If filling with a bobcat or
backhoe fill initial 1/3 of bed
slowly. Also when filling your
veggie bed do not climb in as
this puts unnecessary pressure
onto the bed.
IMPORTANT
ASSEMBLY
CONFIGURATIONS
DUE TO THE MANUFACTURING PROCESS BED SIZING MAY VARY +/-50MM
Remove protective plastic covering (on all
coloured beds). Choose shape from available
configurations (as shown below) and lay panels
out on ground accordingly.
INSIDE
OUTSIDE
Attach all nuts loosely & then tighten with a
screwdriver. A cordless drill will assists with this
process. Failure to tighten each nut and bolt to
its maximum may cause failure.
Assemble all side panels first then attach
corners.
ENSURE THAT YOU ATTACH THE CORNERS
ON THE OUTSIDE OF THE STRAIGHT SHEETS
Simply push the rubber edging onto the rolled
steel edge and trim excess. The safety edging
is designed to lock onto the rolled steel edge
making it more permanent.
If you have trouble getting the eding onto the
overlapped sheets, use a butter-knife to pry
and rotate it open.
Ensure 23.6in sheets are po-
sitioned as shown otherwise
brace will not align.
