Assembling 2 Arches with 1 set of Connectors
Parts List
(4) BOTTOM SIDE PANELS (holes at the top)
(4) TOP SIDE PANELS (holes at the top and bottom)
(4) CURVED PANELS
(4) TOP CURVED PANELS
(14) PLATES
(56) SHORT BOLTS & NUTS
(4) LONG BOLTS & NUTS
(7) CONNECTORS
WRENCH
Tools required
Stepladder
NOTE:
Assembly requires at least 4 people and MUST be installed on level ground.
5.
Follow Steps 1 & 2 to assemble an Arch on the ground and attach 7 PLATES to one side of it. Repeat to assemble the other Arch,
making sure the PLATES are on the opposite side.
6.
With at least two people per Arch, carefully lift them upright and position them parallel to each other with the PLATES facing out.
Line up the holes in the ends of the CONNECTORS with the open spots on the Arches and attach them using the remaining SHORT
BOLTS & NUTS (
Fig. 3
). Use the WRENCH to make sure all of the NUTS & BOLTS are tightened into place.
7.
Straighten the sides of your Arches, then press the ends of the BOTTOM SIDE PANELS into the ground, marking it. Move the
Arches to the side and use your rubber mallet to gently pound the Stakes into the marked spots. Place the open ends of the
Arches over the tops of the Stakes.
Assembling 3 Arches with 2 set of Connectors
Parts
List
Tools
required
(6) BOTTOM SIDE PANELS (holes at the top)
Stepladder
(6) TOP SIDE PANELS (holes at the top and bottom)
(6) CURVED PANELS
(6) TOP CURVED PANELS
(14) PLATES
(84) SHORT BOLTS & NUTS
(6) LONG BOLTS & NUTS
(14) CONNECTORS
WRENCH
NOTE:
Assembly requires at least 4-5 people and MUST be installed on level ground. You can
use this method to attach 4 or more Arches together by repeating Steps 9 & 10.
8.
Follow Step 5 to assemble the two outside Arches. With at least two people per Arch, carefully lift them upright and position them
parallel to each other with the PLATES facing out and enough room for the 3rd Arch in the middle.
9.
Slide the TOP and BOTTOM SIDE PANELS of the 3rd Arch together and position them between the first two Arches. Attach the
PANELS to one Arch and then the other by lining up the holes in the CONNECTORS with the open spots pointed out in
Fig. 2
and
using the SHORT BOLTS & NUTS to secure them (
Fig. 3
).
10.
Using
Fig. 1
as a reference, continue sliding the pieces of the 3rd Arch together and securing it to the other Arches using the
CONNECTORS. Once all the pieces are in place, secure the TOP CURVED PANELS together by sliding the LONG BOLTS & NUTS
through the lined up holes in the top (
Fig. 1
). Use the WRENCH to make sure all of the NUT & BOLTS are tightened into place.
11.
Straighten the sides of your Arches, then press the ends of the BOTTOM SIDE PANELS into the ground, marking it. Move the
Arches to the side and use your rubber mallet to gently pound the Stakes into the marked spots. Place the open ends of the
Arches over the tops of the Stakes.
CONNECTOR
NUTS & SHORT BOLTS
ARCH 1
ARCH 2
Figure 3
