Tilting the motor unit:
0°
15°
30°
45°
60°
-15°
-30°
-45°
-60°
0
1
The motor unit
1
can be tilted in 15° increments from
60° to – 60°.
1. Remove the battery from the handle (see 4. Initial Operation).
2. Keep both orange buttons
0
pressed.
3. Tilt motor unit
1
in the required direction.
4. Release both orange buttons
0
and allow motor unit
1
to
engage.
5. Put the battery on the handle (see 4. Initial Operation).
Extending the telescopic
pipe:
50 cm
q
2
The telescopic tube
2
can be continuously extended by up to
50 cm.
1. Remove the battery from the handle (see 4. Initial Operation).
2. Loosen the orange nut
q
, extend the telescopic pipe
2
to the
require length, and tighten the orange nut
q
again.
3. Put the battery on the handle (see 4. Initial Operation).
Starting the Pole Pruner:
w
r
t
DANGER!
Physical injury due to cut injury!
v
Never override the safety devices (e.g. by strapping
down the starting lock-out and/or the start button).
Verify that the following conditions are met before
commencing work:
• The tank has been filled with sufficient chain oil
and the lubrication system has been checked
(see 4. Initial Operation).
• The chain is tensioned (see 7. Maintenance).
Switching on the Pole Pruner:
1. Open the snap fit of the protective cover
w
and remove from
the bar.
2. Slide the battery onto the handle (see 4. Initial Operation).
3. Hold the telescopic pipe of the Pole Pruner with one hand and
the handle with the other hand.
4. Push the starting lock-out
r
forwards and press the start
button
t
. The Pole Pruner starts.
5. Release the starting lock-out
r
.
Switch off the Pole Pruner:
1. Release the start button
t
.
2. Remove the battery from the handle (see 4. Initial Operation).
3. Slide the protective cover
w
onto the bar and close until the
snap fit engages.
21
GB
