1. Lift safety flap
(H1)
2. Make sure the discharge chute is clean and
free from debris
(H2)
3. Locate fully assembled grassbox onto 2
location points
(H3)
at the rear of the deck as
illustrated in
pic. J
4. Locate safety flap onto the top of the grassbox.
Ensure the grassbox is securely located.
•
IMPORTANT ! AFTER FITTING ENSURE NO
GAP REMAINS BETWEEN THE SAFETY
FLAP AND THE GRASSBOX.
•
Removal is the reverse procedure.
•
For larger areas of grass where grass
collection is not required you can use your
lawnmower without the grassbox. The design
of the safety flap permits the cut grass to be
discharged downward behind the machine.
Fitting Grassbox to Lawnmower
H
1
3
J
PAGE 6
2
Cutting Height Adjustment
Cutting Height Adjustment
• Height of cut is adjusted by raising or lowering the
wheels using the height adjustment lever
(K)
• There are five heights of cut on this product
(20 - 60 mm).
• NOTE
A medium height of cut is recommended for
most lawns.
The quality of your lawn will suffer and
collection will be poor if you cut too low.
K
Starting and Stopping
L1
L2
To Start your Lawnmower
1. Connect female extension cable connector to
the back of the switchbox.
(L1)
2. Form loop in mains cable and push the loop
through the slot.
(L2)
