background image

20

GB

G

F

ATTENTION ! Damage to the hedge trimmer ! 

A

V  

Never clean the hedge trimmer under running 

                   water or with a water jet (in particular a high 
                   pressure water jet). 

1.  Clean the hedge trimmer with a damp cloth. 

2.  Lubricate the trimmer blade

G

with a low viscosity oil (e.g.

GARDENA spray-oil 

Art. 2366

). Avoid contact of the oil with 

the plastic parts and wear gloves. 

8. Troubleshooting 

DANGER ! Risk of physical injury ! 

A

 

Cutting injuries can be caused if the hedge trimmer 

              does switch on unintentionally. 

    

V

 Remove the battery before troubleshooting

                   (see 4. Initial Operation) and slide the protective 
                   cover 

F

over the cutter blade

G

.

Fault                                                Possible cause                             Remedy 

Hedge trimmer does not start 

    Battery is flat.                                 

v

 Charge battery (see 

                                                                                                                    4. Initial Operation). 

                                                        

Battery not pushed onto                 

v

 Push battery onto the handle

                                                        the handle properly.                             and make sure that the 

                                                                                                                    locking buttons snaps in 
                                                                                                                    correctly. 

                                                        When rotating the cutting unit, it    

v

 When rotating the cutting 

                                                        was not engaged at 0° or 90°.            unit, engage it at 0° or 90°. 

                                                        When tilting the swivel head, it       

v

 When tilting the swivel head,

                                                        was not engaged between 75°           engage it between 75° and 
                                                        and -45°.                                             -45°. 

Hedge Trimmer does not 

             Hedge Trimmer overheats.             

v

 Let Hedge Trimmer cool for 

start / starts only briefly 

                                                                          30 seconds. 

Hedge is not cleanly cut 

             Blade blunt or damaged.                

v

 Have blade replaced by 

                                                                                                                    GARDENA-Service. 

Charging indicator lamp does     

Battery not plugged in                    

v

 Plug in battery charger and 

not light up 

                                   properly.                                               charging cable properly. 

Charging indicator lamp               

A fault has occurred.                      

v

 Unplug and reinsert 

flashes for more than 

                                                                              charging cable. 

The fault 

1 hour 

                                                                                                        will be reset. 

The battery can no longer            

Battery is defective. 

                      

v

 Replace the battery 

be charged 

                                                                                                (Art. 8835 / 8839). 

                                                        Only the original GARDENA Replacement Battery 18 V 
                                                        (Art. 8835 / 8839) may be used. This can be obtained from 
                                                        your GARDENA dealer or directly from GARDENA Service. 

Telescopic tube slips despite 

     Nut / s loose on clamping lever / s.   

v

 Tighten nut / s on clamping 

clamped clamping lever / s                                                                        

lever / s using a 10 mm 

                                                                                                                    spanner. 

G

F

Summary of Contents for HighCut 48-Li 8882
















Reviews: