4. MAINTENANCE
DANGER! Risk of injury!
Cut injury when the product starts
accidentally.
v
Before you maintain the product, make sure that
the protective cover
1
is slid over the blade
2
[ Fig. I1 ].
To clean the Grass Shear [ Fig. I1 ]:
DANGER! Electric shock!
Risk of injury and risk of damage to property.
v
Do not clean the product with water or with
a water jet (in particular high-pressure water jet).
To increase operating time, the product should be cleaned
and sprayed after each use.
1. Clean the product with a damp cloth.
2. Lubricate the blade
2
with a low viscosity oil
(e. g. GARDENA spray-oil Art. 2366). Avoid contact
with the plastic parts.
5. STORAGE
To put into storage [ Fig. I1 ]:
The product must be stored away from children.
1. Charge the battery. This increases the life of the battery.
2. Clean the product (see 4. MAINTENANCE) and slide
the protective cover
1
over the blade
2
.
3. Store the product in a dry area where it has protection
from frost.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal
household waste. It must be disposed of in line with local
environmental regulations.
IMPORTANT!
Dispose of the product through or via your municipal
recycling collection centre.
Disposal of the battery [ Fig. S1 ]:
The GARDENA battery contains lithium-ion cells that
should not be disposed of with normal household waste
at the end of its life.
IMPORTANT!
Dispose of the batteries through or via your municipal
recycling collection centre.
1. Discharge lithium-ion cells
8
completely.
2. Remove lithium-ion cells
8
from the product.
3. Dispose of lithium-ion cells
8
properly.
6. TROUBLESHOOTING
DANGER! Risk of injury!
Cut injury when the product starts
accidentally.
v
Before you troubleshoot the product, make
sure that the protective cover
1
is slid over the
blade
2
[ Fig. I1 ].
To change the blade [ Fig. T1 ]:
Only an original GARDENA blade is allowed to be
used. A new blade can be ordered by the GARDENA
Service.
1. Pull the flap
(9)
upwards and slide the lid
(10)
downwards.
2. Remove the blade
2
.
3. If necessary clean the transmission chamber and lubri-
cate the excentric drive
q
with some acid-free grease
(Vaseline).
4. Turn the excentric drive
q
downwards.
5. Pull the crank
w
on the back side of the blade
2
in the
middle.
6. Place the new blade
2
on the motor unit in such a way
that the excentric drive
q
is inserted in the crank
w
.
7. Slide the lid
(10)
upwards until it makes a click.
Problem
Possible Cause
Remedy
The jack flashes red
while charging
Allowed battery temperature
was exceeded.
v
Let the battery cool down. Restart
the charging.
Runtime too low
Blade soiled.
v
Clean and lubricate scissor blade in
accordance with the maintenance
instructions.
The product does not
cut cleanly
Blade blunt or damaged.
v
Change the blade
(see To change the blade).
EN
13
