14
GB
3. Assembly
All 4 wheels must always be screwed in at the same cutting
height (see 4 Operation “Setting the cutting height”).
1. Insert screw
1
through the bore in the hub cap
2
and push
the 6-sided head fully into the hub cap
2
.
Insert the short screw in the small hub cap and the large
screw in the large hub cap.
2. Press covering cap
3
into the hub cap
2
until it snaps in
place.
3. Insert screw
1
through the wheel
4
and screw the wheel
4
firmly in place by hand at the side and ensure it is securely
located.
Screw in the small wheels (13 cm diameter) at the front
and the large wheels (16 cm diameter) at the rear.
1. Place the box cover
7
on the grass box
8
from above in such
a way that
ALL
the eyes
c
are positioned over the hooks
d
.
2. Press the box cover
7
on to the grass box
8
until the hooks
d
engage securely.
3. Inspect: Check that all the hooks
d
are engaged securely.
4. Operation
DANGER !
A
Cutting tool can cause injuries !
V
Wait until the cutting tool is stationary before
undertaking any adjustment work, wear suitable
work gloves and pull out the mains plug.
34 E easyMove
Fitting the wheels :
Fitting the grass box :
The mains voltage and the equipment voltage
stated on the type plate must be the same. If
extension cables are used, these must comply
with the minimum cross-sections in the table
below :
Voltage
Cable Cross-
length
section
220 - 240V/ 50 Hz
Up to 20 m
1.5 mm
2
220 - 240V/ 50 Hz
20 - 50 m
2.5 mm
2
A brief voltage dip may occur when you switch
on your shredder (due to conditions of the
power supply) that may affect other devices
(e.g. a lamp may flicker).
This problem should not occur with supply
impedances of Z
max
< 0,46 Ohm.
8
d
c
7
3
1
2
4
