15
GB
B
0
A
9
C
5
D
1. Press in both slides
9
simultaneously and open up the
steering upright
0
.
2. Open the clamping lever
A
.
3. Pull out swivelling upright
0
to the required length.
4. Close clamping lever
A
again.
For safety reasons, on first use, the upper part of the
handle must be drawn out fully. It can then no longer
be collapsed to the as-delivered position.
The clamping force can be adjusted via the nut
B
. If the
clamping effect decreases, open the clamping lever and
turn the knurled nut clockwise (e.g. with pliers).
1. Push extension cable connector
C
on to the mower plug
D
.
2. Form a loop with the extension
cable
E
and guide it thorough the
cable strain relief
5
.
3. Hook in extension cable
E
in such
a way that the cable sags slightly
and the cable strain relief can slide
along the entire length of the
cable clip.
Note: To avoid driving over the extension cable, the exten-
sion cable should always be arranged in such a way that
when the mower is operating, the cable is routed in from
the side which has already been mowed.
DANGER ! Risk of injury if the mower does not switch
A
off automatically !
V
Do not remove or bypass the safety devices
(start button, switch handle).
1. Place mower on a flat area of the lawn.
2. Press the start button
F
and pull the switch handle
G
on the
steering wheel
H
.
3. After starting the motor, release the start button
F
again.
4. Only push the mower forwards and at walking pace.
For 34 E easyMove :
The cutting height can be adjusted from 2.0 to 6.5 cm in 1.5 cm-
stages (4 positions).
v
Unscrew wheels
4
by hand and screw back in firmly at the cut-
ting height required.
All 4 wheels
4
must always be screwed in at the same cutting
height (see scale
z
S
on the back of the wheel mounting).
Adjusting the swivelling
upright :
Connecting the extension
cable :
Starting the mower :
Adjusting the cutting
height :
F
G
H
4
z
S
E
5
