TZ OPTIC FIBER 400 INNOMINABILE
Use and maintenance manual
Rev. 02/18 - UK
Via Leonardo da Vinci, 32/B
36034 Malo (VI) Italia
28
5.5.3 TRACKING DISASSEMBLY
The tracks used in the «TZ FIBER 400» excavator
have a structure with an internal steel core and a
rubber coating (Fig. 18). The sculptures are used
to provide stability when walking on soft ground.
These are located in the lower part resting on the
ground, while the wheel guides located inside the
track, prevent the track from coming out of the gui-
de rollers.
An incorrect use of the machine and a use of the
machine on stony and rough terrain, lead to an
early wear of the tracks.
Should it be necessary to replace the tracks, ope-
rate as follows.
After bringing the machine on firm and level
ground, lift the machine up of safety by placing
very stable supports underneath the undercarriage
frame that can support the whole.
1) Remove the screws and remove the cover (1
Fig. 15) for access to the regulation.
2) Remove the stop (2 Fig. 16)
3) Completely loosen the nut (3 Fig. 16) bringing it
closer to the stop (5 fig.16) - use a 38mm spanner
4) Insert the supplied pins. Fix the screw very well
in order to avoid distortion
5) Use a tool similar to the following (not supplied),
hook both pins and tighten until the track loosens
