16
CAUTION
8-13. INSTALL LIGHT BULBS AND LENSES
• Install a maximum 60 W incandescent bulb (not provided) into lamp
socket(s).
• Install lamp lens(es). Two lenses for a CarGo 700e model (see Fig.
27A). Lenses are not interchangeable, the design is left / right
orientation dependent. One lens for a CarGo 500e model.
• Line up lamp lens tabs with slots in housing and snap securely into
place. Repeat same procedure with second lamp lens on the
opposite side, if you have an CarGo 700e power head.
• Line up lamp lens tabs with corresponding slots in chassis. Snap
lens onto chassis for CarGo 500e model.
• To remove lamp lens, pull lamp lens to unsnap from housing
and chassis.
Hinge lamp lens downward
line up tabs with slots in housing
and snap into place.
Snap lamp lens tabs
into slots in chassis
Install Bulb
CarGO 700e
CarGO 500e
Housing Slots
Chassis Slots
Lens Tabs (housing)
Lens Tabs (chassis)
Chassis Slots
Housing
Slots
Install Bulb
Snap lamp lens tabs
into slots in chassis
Hinge lamp lens downward
line up tabs with slots in housing
and snap into place.
Standard incandescent
light bulb 60W (max.)
Lens Tabs (chassis)
Standard incandescent
light bulb 60W (max.)
Fig. 27
Warning
To prevent possible serious injury and damage to
the operator when replacing the light bulbs:
Disconnect ALL electric and battery power BEFORE
performing ANY service or maintenance.
NOTE:
Use only standard light bulbs. The use of short neck or specialty light bulbs may overheat the endpanel or light socket.
Left lens
80349
Right lens
80348
Fig. 27A
To prevent possible OVERHEATING of the end panel or
light socket:
• Use ONLY standard incandescent light bulb(s).
• DO NOT use a bulb with a rating higher than 60 Watts (W).
A stronger or larger bulb may result in fire or damage to the
opener.
To prevent possible radio frequency (RF) signal
interference:
• Do not use compact florescence lighting (CFL).
Summary of Contents for CarGO 500
Page 1: ......
