Ganz ZN1-V4FN3, Installation Manual

Page: 17 / 35

PixelPro GXi Series ZN1-V4FN3/FN4 Installation Guide
06-2014-B 17
LAN connector
3) Connect the main unit to the network using an Ethernet cable (RJ45). Then, install the ferrite
core on the Ethernet cable. Refer to the explanations below for the ferrite core installation.
In case you intend to power the device using the LAN cable, a PoE switch should be available
in your network. Refer to “
Appendix (B): Power over Ethernet” for more details.
Use of the ferrite core
Installation of the provided ferrite core is highly recommended to reduce high frequency
electrical noise level. Here below are the instructions to install the ferrite core on the Ethernet
cable.
Power connector
4) Connect a 12VDC power adaptor to the power connector on the main unit.
If the camera is powered via PoE, a power adaptor is not necessary to be connected to the
main unit.
1) Open the ferrite core by lifting the clip.
2) Make one loop with the cable through the ferrite core. (See the enlarged image above.)
3) Close the ferrite core to hold the cable loop in the ferrite core’s chamber.