Ganz ZN-M2AF, User Manual

Page: 23 / 28

22
Firmware Update Procedure
1. Save the firmware file to your computer.
2. Go to Setup > System > Maintenance within the camera web browser setup.
3. In the Firmware Update section, browse to the desired firmware file on your
computer. Then Click OK.
NOTE: Do not disconnect power to the unit during the upgrade. The unit will
restart automatically after the upgrade has completed. (1~5 minutes)
4. If you suspect the firmware upgrade for the camera has failed, always wait at
least 5-10 minutes before restarting the upgrade process.
5. CBC reserves the right to charge for any camera repair which can be
attributed to faulty upgrading by the user. Always read the upgrade
instructions and firmware release notes before updating the firmware.
System Reboot
There are two ways to reset the camera.
Case 1) Using the web browser:
1. Go to SETUP > System > Maintenance.
2. Click “System Reboot Button” and wait 1 minute for camera to reboot.
Case 2) Using the Reset Button of the camera:
1. Press and keep for 5 seconds than release the button.
Factory Default Reset
There are two ways to reset the camera back to factory default.
Case 1) Using the web browser:
1. Go to SETUP > System > Maintenance.
2. Click Factory Default Button
.
Case 2) Using the Reset Button of the camera:
1. Push & hold the reset button more than 10 seconds.
2. Release the reset button.
NOTE: The unit will now have the default IP address from a DHCP server.
Use the ‘PixelPro Discovery Tool’ to discover and connect to the camera.