3
www.gantner.com
Valid as from July 30
th
, 2013 • Technical data subject to modifications without notice!
DB_GAT-ACCESS6100--EN_11.indd • PartNo.: 860279
Mounting and installation instructions
The device back part is secured by screws to a flat background (e.g.
concrete wall). When fixing to an uneven background the device back part
must not be distorted as this will prevent correct connection of the upper
part. Recommended mounting height: top edge of device 1.3 m.
Use the drilling template which is attached to the device.
Mounting the device upper part
Once the connection cables are terminated, the device back part and upper
part are connected together via a connection cable (already connected in
the upper part) and the two parts are fixed together.
1. 2.
Notes:
1. Check the socket in the device back part (circled in figure 1). Dirt,
dust and humidity must be removed so that a good contact of the
connection cable is guaranteed. No aggressive detergent may be
used. Please do not damage socket contacts.
Attention: Cleaning only in powerless state.
2. Plug in the connection cable into the socket in the device back part
(consider alignment) and clip the top of the device upper part into the
device back part.
Wall mounting
Cables can be flush (1) or suface-mounted (2).
When surface mounting please check whether the cables can still be
inserted once the device back part has been mounted, otherwise run the
cables through the cable lead-ins prior to securing.
1. Flush-mounted cable
2. Surface-mounted cable
3. Back box
4. Device back part
5. Cable conduit for surface cable connection
3. 4.
3. Swing down the device upper part until it clicks.
4. The device can only be opened with the supplied special tool! With
this the two catches on the bottom of the device can be unlocked in
succession.
69 mm (2.72”)
13 mm (0.51”)
18.5 mm (0.7
3”)
28.5 mm (1.12”)
20 mm
(0.7
9”)
71 mm (2.8”)
60 mm (2.36”)
2
3
4
5
1
