![background image](http://html1.mh-extra.com/html/gantner/gat-access-6100-series/gat-access-6100-series_installation-commissioning-and-operation_3420908060.webp)
GAT Access 6100 Terminal Series
Commissioning & Configuration
60
HB_GAT-ACCESS6100--EN_14
www.gantner.com
- FeedbackLocked:
Is shown if the connected turnstile is already turned and the user holds data carrier to
the reading field, e.g. for entry or exit.
- Allow:
Is shown if access is granted for a user.
- Denied:
Is shown if access is denied for a user.
- OutOfService:
Is shown if no communication is active with a host and the Online Emergency mode is
switched off (not used).
- RemoveCard:
Is shown if the GAT Access 6100 reads the same data carrier twice or several times
without it being removed before. The data carrier must be removed from the reading
field.
- WaitPermission:
Is shown while the GAT Access 6100 is waiting for a response from the host computer
after the terminal has read a data carrier and sent a request to the host.
- Default_Deny_01 ... _19:
Depending on the status value of 1 up to 19 in the answer to a Card_Ident command
the corresponding display text will be shown and access is denied.
5.5
Configuration of Offline Emergency Mode for a GAT Access 6100
In Offline Emergency mode, it is possible to read data from any block within any sector of a data carrier. With a
configurable mask the read data can be separated into relevant and non-relevant data. The check for access
authorization in Offline Emergency mode is then done by comparing the relevant data with a predefined result value.
If the relevant data matches exactly the defined result value, access is granted. Otherwise, access is denied.
To use Offline Emergency mode, an Offline License from GANTNER Electronic GmbH is required. To receive this
license, send the serial number and MAC address of the GAT Access 6100 to GANTNER in order to generate the
license code. The license code can then be entered into the GAT Access 6100 using GAT Config Manager. The
following instructions explain how to configure Offline Emergency Mode in GAT Config Manager.
For more information on GAT Config Manager, see "5.4. Configuration Settings".
1. Firmware version 2.6.0 or later must be installed in the GAT Access 6100. Instructions on how to update the
firmware are provided in chapter "7 UPDATING THE GAT ACCESS 6100".
2. In GAT Config Manager, enter the Site Key information in the configuration option "Reader" -> "MIFARE" -> "Site
key" or "Reader" -> "LEGIC" -> "Site key" respectively.
Summary of Contents for GAT Access 6100 Series
