Game ready ATX CRYO CAP WRAP, Use Manual

Page: 1 / 76

CRYO CAP
USE GUIDE
ENGLISH
ASSEMBLY
The Heat Exchanger
(PN 520920-03)
fits inside the Sleeve
(PN 510920)
and
comes as part of a pre-assembled Wrap
(PN 590920-03)
. If the Heat
Exchanger is removed to launder the Sleeve or for any other reason,
please use the following instructions to re-insert the Heat Exchanger
into the Sleeve.
SIZING SPECIFICATIONS
• Size: One Size
WARNING
It is mandatory to fully read and understand your
System’s User Manual before using the device.
Failure to follow operating instructions could result in
serious injury.
IMPORTANT
Read complete indications, contraindications,
cautions, and warning before using this product.
Keep this document for future reference.
REMOVAL OF HEAT EXCHANGER
1. Disconnect the Connector Hose from the Wrap
2. Unzip the zipper
3. Gently pull out the Heat Exchanger
STORAGE OF YOUR WRAP
Hang your Wrap on a wide hanger or lay flat. Do not fold or stack it, as
this could kink the fluid chamber and the Wrap will not work properly.
1
Lay the Sleeve with the zipper side up
on a flat surface and with the GR badge
facing toward you. Place the Heat Exchanger
on a flat surface, separate from the outer
Sleeve, with the blue side down.
2
Take the two long, upper pieces of
the Heat Exchanger and overlap
them. While overlapped, insert the Heat
Exchanger into the Sleeve by sliding the
two overlapped pieces into the center
pocket of the Sleeve. The blue side of the
Heat Exchanger should touch the blue side
of the Sleeve.
3
Feed the ATX connector through the
connector opening on the side of the
Sleeve. Tuck the neck flap into the pocket
across from the connector.
4
Overlap the three wing-like pieces on
one side of the Heat Exchanger. Insert
the wing-like pieces into the corresponding
side wing space of the Sleeve. The wings will
remain overlapped in the provided space.
5
Once the first wings are in place, zip
together that side of the Sleeve to keep
the Heat Exchanger in place. Repeat the
previous step for the opposite side of the Wrap.
6
Zip the Sleeve fully, making sure the
Heat Exchanger is lying smoothly in the
Sleeve with no kinks or folds. Attach the hook
and loop forehead closure. Feed one end of
the chin strap through the ear loop and fasten
the tab on the outside of the chin strap.
FOR USE WITH
GAME READY
GRPRO
®
2.1 SYSTEM
SUPERSEDED