Master II Gun
Service Manual
16/21
2.0 Issue
Ref. NR-00021-ENG
http://www.gamapur.com/
9.
Verify that the accommodation of the trigger shaft is free of dirt and wall light a small fat
layer in his interior.
10.
Mount the air hose in the rear part of the gun using sealing paste in the thread to avoid air
escapes.
11.
Insert the trigger shaft in to the spring and insert it inside the handle taking special care not
to damage the o-rings. You will note a certain resistance caused by the interference of the
seals with the housing wall.
12.
Screw down the trigger valve nut until it does ceiling in the fund.
13.
Fit the trigger with the bolt and hold it with the retention nut.
14.
Place the trigger stop bolt. It must be tight up to eliminating the roominess of the trigger
shaft (without to displace the shaft).
15.
Fix the mixing block according to the procedure described in the pistol block unit and mix
chamber assembly section.
16.
Start the gun.