6 Easy steps on how to install sleeve anchors.
After using the base as a template and marking the three holes.
1.
Use an electric drill with a bit the size of the *sleeve, drill a hole 2.5
”
deep in the
desired spots (FIG 1).
2.
Clean the hole from residue from the drilling.
3.
Place the sleeve and anchor into the hole and make sure to leave 2
”
exposed (FIG 2).
4.
Place the First washer over each anchor, then place the base of your unit over the
screws (FIG 2).
5.
Place the second washer and spring washer over the unit and tighten clockwise with
the provided nuts (FIG 3).
6.
After finishing place the black decorative cap over the nuts.
FIG 2
First washer
FIG 3
Nut
Spring washer
Second washer
*The sleeve is the outer part that is covering the screws
FIG 1
