2
Fig. 3
Fig. 4
B
A
Fig 5
C
B
Fig 6
Assembly Instructions
1. Mark three holes using the template and drill the holes using a 0.5-inch drill
bit, into a solid surface no smaller than the fastening screws. The holes shall
be lined up with the holes of the lamp base
2.
Put the fastening screws (included) into the drilled holes with their threaded
ends facing up
(Fig 3).
3.
Place lamp base onto fastening screws and secure base with the nuts using a
wrench
(Fig 4).
4. Make sure the lamp base (A) is stable before proceeding in installation.
5.
Place part (B) over part (A) and using a wrench tighten the three screws that
are provided. Make sure that the rubber washers go between part (A) and
part (B)
(Fig 5).
6.
Place part (C) over part (B) and tighten with a Philips head screwdriver the
four screws that are provided
(Fig 6).
