page 3
Operation Switch
4
. Install the GS Solar LED
Bulb to the light cap.
9
. Place the Remote-Control Sensor on the
underside of the location for the solar panel,
where it can be exposed for clear operation.
Install by peeling the adhesive cover and
attaching it to the surface.
8
. Connect the wires together and
tighten it firmly to avoid water
getting inside the connection.
5
. Install the light
cap to the lamp
fixture.
Secure using the
two screw caps.
6
. Install the ceiling
mounting bracket at the
desired location using
the supplied screws.
7
. Install the solar panel in
a position where it will
be exposed to the sun,
make sure the wire can
reach the lamp.
NOTE: When installing the GS Solar LED Bulb, hold it from its silver base not by the glass.
NOTE: Before installing the
solar panel, make sure to
switch the On/Off switch
to the ON position, located
under the solar panel.
