3” Fitter Mount
NOTE:
If you are replacing an existing gas
electric post light, you must consult a certified
technician to disconnect them before
installation.
1. Attach the 3” fitter fixture (D)
by sliding the mount over your
existing pole and secure using the
3 set screws.
NOTE:
Be sure to not overtighten the set
screws.
Pier Mount
NOTE:
There are specific types of screws for specific
surfaces. If you’re unsure of the appropriate type
of screw to use on your desired surface, please
consult a professional.
1. Use a drill to make tow holes in
the desired mounting location
(use the pier mount fixture (C) as
a template for drilling locations)
2. Insert the anchors into the holes and
secure the fixture (C) to the surface using
the provided screws.
Wall Mount
NOTE:
Installing the light on a wall may limit
the solar panel for sun exposure. Make sure
the lamp is mounted so direct sun exposure
is available.
1. Remove the silver backet from
the Wall Mount Fixture (E) by
removing the two screw caps.
2. Use a drill to make two holes in the
wall where the lamp will be mounted.
(use the wall mount as a template
for drilling locations but make
sure to keep the two screw posts
horizontal)
3. Place the anchors into the holes
and secure the bracket to the wall.
4. Secure the wall mount fixture (E)
to the wall by sliding the fixture on
to the bracket and securing with the
two screw caps.
1.
Remove the two screw caps from the top (B).
2. Install the GS Solar LED Bulb into the lamp by holding it at the base
and turning clockwise.
3. Turn the operation switch to your desired setting:
Low = Softer light output and longer duration
High = Brighter light output
4. Place the top (B) back on the fixture and secure with the two screw
caps.
5. Install the finial (A) into the top (B) by twisting clockwise.
Assembly Instructions
Operation Instructions
Replacement Batteries and Bulbs are available at
www.gamasonic.com or via our Toll Free number: +1-800-835-4113
Your Lamp can use the following bulbs:
A50WW10W – included bulb with Warm White LEDs (2700K)
A50BW10W – bulb with Bright White LEDs (6000K)
F30WW05W –Flame bulb with simulated flame LEDs
T45WW10W – Edison LED Bulb with Warm White LEDs (2700k)
Your Lamp uses two of the following battery:
GS32V30
Replacement Parts
page 3
