Version 1, 17 March 2021, Page
4
of
12
PRE-INSTALLATION
CHECK CONTENTS
-
Separate all parts from the packaging and check each part with the pack contents section.
-
Make sure all parts are present before discarding any packaging material. If any parts are missing, do not
attempt to install your electronic faucet. Contact Galvin Specialised.
WARNINGS
-
Do not install the system facing a mirror or any other electronic system operated by an infra-red sensor.
-
To prevent reflection problems, it is recommended to keep a minimum distance of 300 mm between the soap
dispenser and any other objects.
IMPORTANT:
-
Keep in mind that when using the faucet installed next to the soap dispenser, the user hands should not
interfere with the soap dispenser sensor detection area. Liquid soap dispensers, with proper care, will provide
long term trouble free service. Quality liquid soap of recommended viscosity and pH levels are the main factors
for smooth operation of your dispenser. If needed, use a viscometer to verify the viscosity of your soap to
ensure maximum benefit. The recommended range for liquid soap viscosity is 100-3800 cPs. Thicker liquid
soap flows slower and inhibits the pump valve, causing strain and damage.
-
Liquid soap dispensers are suitable for use with any generic liquid soap of the correct viscosity and pH. The
pH level of all soap used in our liquid soap dispensers should be between 6.5 to 8.5. Lower levels will cause
corrosion to the metal dispenser and even the rubber and plastic components. Higher pH levels will cause
swelling to rubber parts and degradation of plastic components over time.
INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions
and in accordance with your local regulatory requirements. Electrical supply conditions must also comply to
the applicable national and/or state standards. Failing to comply with these provisions shall void the product
warranty and may affect the performance of the product.
1. Drill hole & Disassemble body
-
Drill a hole (23 to 24 mm) at the desired location
for the soap dispenser spout installation.
-
Remove the hexagonal nut and the disk from the
base of the soap dispenser spout.
-
Disconnect the soap dispenser body with the
rosette from the base by unscrewing the grub
screw.
2. Mount Soap Dispenser
-
Mount the soap dispenser base into the opening
in the wall and secure it using the anchors
provided in the package.
-
IMPORTANT:
The soap dispenser base should
be installed so that the outside surface of the
finished wall falls between the minimum and
maximum lines marked at the base.
-
Assemble
the
temporary
protective
soap
dispenser base cover.
