© Galvin Engineering Pty Ltd
Version 1, 1 June 2022, Page
5
of
6
Product Installation Guidelines
Version 1, 25
th
May 2022, Page
5
of 6
8. Fit handle
−
Ensure the spindle is in the closed
position and firmly press the lever handle
onto the spindle in the desired
orientation.
−
Check operation of lever handle. It
should turn freely for a full ¼ turn.
−
Secure the handle in position using the
supplied washer and stainless-steel cap
screw.
9
.
Fit water temperature indicator & Test
−
Once the lever handle is secure; fit the
appropriate water temperature indicator.
−
Check the operation of the unit and inspect
for any leaks.
TROUBLESHOOTING
PROBLEM
CAUSE
RECTIFICATION
Water is not flowing or
inconsistent flow
Shower arm is blocked with
debris.
Remove debris from shower arm.
Leak from hose
connection
Hose connection loose
Check wall coupling locates properly with
hose connection.
Taps are dripping water
Ceramic discs are worn or
damaged
Remove and inspect SBA. Remove
debris and/or replace SBA if damaged.
Tap seat is damaged
Refurbish tap seat using a reseating tool.
Water is leaking from
spindle
O-ring on jumper valve spindle
is damaged or worn
Replace o-ring
Water is not flowing from
tap
Water is turned off
Turn on water
Aerator or flow regulator is
blocked by debris
Remove aerator and/or flow regulator
from tap and remove debris. Install an
inline strainer.
Spindle is difficult to turn
Build up of scale on spindle,
spindle worn or o-ring has
been damaged
Remove cartridge sleeve, clean and
regrease. Replace o-ring. Complete SBA
may need to be replaced.
Handle is loose
Screw has come loose
Tighten handle screw
Flange does not screw
down onto wall surface
Wall bodies are set too far out
Re-position tap bodies
