© Galvin Engineering Pty Ltd
Product Installation Guidelines
Version 2.1, 2 December 2021, Page
6
of 6
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but
not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engine
ering Pty Ltd products are covered under our manufacturer’s warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in
the manufacturer’s warranty. During the warranty period, Galvin Engineering will replace or repair any
defective products manufactured by Galvin Engineering without charge, so long as the terms of the
Manufac
turer’s warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
TROUBLESHOOTING
PROBLEM
CAUSE
RECTIFICATION
Tap is leaking
Cartridge damaged
Remove and inspect the cartridge,
remove debris and/or replace if
damaged
Tap incorrectly installed
Follow the installation steps above
when fitting the tap.
Tap has inconsistent flow
Blocked flow regulator
Follow the instructions above to
remove flow regulator from the body
and check for debris. Install an inline
strainer to stop further blockages.
Tap moves on basin
Insufficiently tightened
Follow the steps above in relation to
tightening the installation.
Water temperature is opposite to the
handle markings
Inlet hoses connected
incorrectly
Switch the hoses connection on the
inlets
Inlet hoses connected to wrong
isolating valves
Switch the hoses connection on the
isolating valves
