© Galvin Engineering Pty Ltd
Product Installation Guidelines
Version 2.1, 2 December 2021, Page
2
of 6
DIMENSIONS
-
If the mounting hole does not already exist,
mark out and drill the hole in the sink, as
shown in the rough-in dimensions.
Note: Before installation, all lines must be flushed. We
recommend that a line strainer be installed prior to the
CliniLever® Sink Mixer to eliminate any foreign
material.
INSTALLATION
INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these
installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements.
Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
Failing to comply with these provisions shall void the product warranty and may affect the performance of the
product.
1. Fit Mounting Hardware and Hoses
−
Screw in and tighten flexi-hoses. Insert the
flexi-hoses as how the indications on the
handle are shown. (Left hole for Hot and
Right hole for Cold)
−
Fully screw threaded rod as shown.
2. Fit Tap
−
Ensure the sink mounting hole for the tap is as
per the rough-in dimensions.
−
Ensure the Bottom ring is present underneath
the tap.
−
Carefully fit the flexible hoses and threaded rod
through the sink hole as shown.
Version 1, 2 December 2021, Page 2 of 9
Ø30 MIN
Ø38 MAX
Rough-In Dimensions
Bottom Ring
Hot Inlet
Cold Inlet
Threaded rod
