– The manufacturer is not responsible for damage caused by improper use of the appliance
and the accessories and its warranty for the appliance does not apply in situations when
the safety warnings above are not complied with. Failure to replace or maintain all filters
regularly according to the instructions in Chapter
IV.
,
V.
and also using non-original
filters, the properties of which resulted in failure or damage of the vacuum cleaner, is also
understood to be improper use of the appliance.
II. EQUIPMENT AND ACCESSORIES (fig. 1)
A – vacuum cleaner
A1 – suction vent
A9 – handle
A2 – lid
A10 – power cord
A3 – lid lock
A11 – parking holes
A4 – START/STOP button
A12 – exhaust grid
A5 – power cord winding button A13 – exhaust HEPA micro-filter
A6 – electric motor regulation
A14 – filter (adapter) holder
A7 – full filter signaling
A15 – dust filter (dust bag)
A8 – suction micro-filter
A16 – suction micro-filter grid
B – accessories
B1 – floor nozzle
B5 – upholstery nozzle
B2 – suction hose
B6 – brush
B3 – metal telescopic tube
B7 – parquet nozzle
B4 – crevice nozzle
B8 – turbo brush (applies for type ASP 510)
C – adapter for UniBag
(Not included)
C1 – filter head blocking lock
Caution: attachments it is possible to buy these accesories with marks.
III. VACUUM CLEANER PREPARATION
Hose
– Connect suction hose
B2
to the vacuum cleaner keeping the arrow direction according to
Fig. 4. You will hear a clicking sound.
– Disconnect the hose by pressing the button on the end piece and remove the hose by
pulling it slightly.
Metal telescopic tube
– Connect the telescopic tube
B3
with suction hose
B2
according to Fig. 3.
– The telescopic tube allows setting suitable length to fit your figure. Press the lock pin in the
direction of the arrow and pull out or push in the required length of the tube (Fig. 3). When
you release the lock projection, the tube length is fixed. When pulling out, keep
the tube in safe distance from your face as the tube is very long.
– Apply reverse procedure to disassemble.
Floor nozzle / narrow floor nozzle / turbo brush
– Connect and disconnect the accessories (
B1, B7, B8
) in the same way as the tube (Fig. 2).
Floor / crevice nozzle / brush
–
Connect and disconnect the accessories (
B4
,
B5
,
B6
) in the same way as the tube (Fig. 3).
32 / 44
