EN
EN - 31
– Avoid contact with the rotating brush when handling the vacuum cleaner (e.g.
with loose
clothes, hair, fingers, jewellery, bracelets
etc.).
– Do not leave the floor nozzle with the rotation brush on in one place for too long! It could
cause damage to the surface vacuumed!
–
Do not use the brush for treatment and cleaning animal hairs!
–
Do not put the suction nozzle or the tube end or accessories close to eyes and
ears and do not insert them into body orifices!
–
Never use the vacuum cleaner with wet hands or feet!
– When you vacuum a staircase, never leave the vacuum cleaner higher than you stand yourself!
–
Never leave the product unattended when in operation!
–
Never immerse the vacuum cleaner into water (even its parts)!
–
Never vacuum without a properly inserted filtration system and micro
–
filters.
– Pay special attention when using the handle on the dust container (e.g. carrying) to avoid
pressing the lid arrest button. There is a risk of damaging the vacuum cleaner or danger
of injury caused by the falling of the disconnected appliance.
– It is not allowed to modify the surface of the appliance in any way (e.g. using
a
selfadhesive wallpaper, foils
, etc.)!
– Do not place any objects on the appliance.
–
If the appliance was stored in lower temperatures, acclimatize it first.
– Before you start using the vacuum cleaner, please check that all the locking mechanisms
are in the right position.
– Do not vacuum wet or moist floor coverings, do not use the vacuum cleaner for outdoor
areas! When moisture gets into the aggregate, there is a risk of its damage and disabling
it. This defect is not covered by the warranty.
– Vacuum cleaning of some carpet types may result in generating static electricity. No
static electricity discharge is dangerous to health.
– Do not vacuum sharp objects (e.g.
glass, shatter
), hot, flammable, explosive items
(e.g.
ash, hot cigarette butts, gasoline, thinners and aerosol vapours
) or greases
(e.g.
fats, oils
), caustic agents (e.g.
acids, solvents
). Vacuuming these objects may
lead to damage of the dust filters or the vacuum cleaner.
– Do not put fingers or other things to input and output vents of the appliance. If the vents/
elements for air flow are clogged (e.g. the
hose
), turn the appliance off and remove the
clogging.
– When handling, do not pull the hose applying excessive force and avoid rough handling
of the vacuum cleaner!
– The vacuum cleaner is not suitable for vacuuming substances that can harm human health.
– Pores of the micro filters may be clogged when vacuuming very fine dust. Thus, air
permeability will be reduced and the suction performance will drop. In this case, micro–
filters have to be cleaned before the container is full. Do not use the vacuum cleaner to
vacuum dirt produced during/after construction such as
plasterboard dust, fine sand,
cement, dust from construction, parts of plaster
etc. If this dirt / loose construction
materials / loose construction materials into the aggregate, it poses a danger of damage.
The warranty repair does not cover this.
– Always switch off the vacuum cleaner first and disconnect the power cord from power
supply and only then empty the dust container, clean/replace micro–filters, clean the
vacuum cleaner or its accessories.
