Gallagher i Series, Instructions Manual

Page: 11 / 76

10 11
ADDING A CHANNEL
Changing channels
1. Hold down any two buttons for 3 seconds.
The Remote display scrolls through all the “filled”
channels.
2. Release the buttons when the energizer channel you
wish to communicate with is displayed .
To add a new energizer to the list of channels, complete
the following:
1. Hold down any two buttons (ON/OFF/Inquiry) for 3
seconds or more.
The Remote display scrolls through all the “filled”
channels. Before returning back to 1, a “new” channel
is indicated by the magnifying glass icon . Once
this icon is displayed, release the button.
2. Hold the fence connection slot against a wire connect-
ed to the new energizer.
3. Press any button to start the automatic tuning
process.
On successful tuning, the magnifying glass icon is
cleared and the new energizer channel number is
displayed. If the tuning is unsuccessful, the reverse
lightning bolt symbol will flash.
Deleting a channel
1. Hold down any two buttons for 3 seconds.
The Remote display scrolls through all the “filled”
channels.
2. Release the buttons when the energizer channel you
wish to delete is displayed.
3. Press and hold any two buttons for 6 seconds.
After 3 seconds the channel number will start to flash
for a further 3 seconds. If both the buttons are held
until after the flashing period, the channel will be
deleted and the first available channel displayed.
Handy Hint: To remember which channel number is
set to each energizer, use the table at the back of this
manual to record it.
Note: When the battery is removed from the Remote,
all channel information is retained. However, when the
battery is replaced, the channel selection will
reset to
the lowest configured channel.