Galil Visual-ICE MRI, User Manual

Page: 84 / 122

10-4 User Manual
Symptom Potential Causes / Solutions
Touch screen does not respond 1. The track pad may be used to control the system.
2. Turn OFF and restart the system using the power control
knob on the front of the system (Figure 2-2).
Touch Screen goes blank during a
procedure
1. The video cable may be disconnected.
WARNING. Do not touch the screen if the touch screen
monitor goes blank for greater than five (5) seconds
during a procedure. Immediately turn off power to the
system and end the procedure to avoid inadvertent
activation of needles.
2. Contact Galil Medical Customer Service.
10.2.1 Replacing Fuses
Instruction Photo
1. Turn the Power Switch OFF on the rear of the
Visual-ICE MRI Console. Loosen the thumb screw
on the cord retention clip.
2. Remove the power cord from the retention clip.
Remove the two screws that secure the retention clip
and remove the retention clip from the power inlet.
3. Insert a small screwdriver into the slot on the bottom
of the fuse holder to begin to snap the fuse holder
out of the power inlet.