Galaxy AX500, Safety, Operation & Maintenance Instructions

Page: 8 / 33

Galaxy Manual 1/7/15 Page 8 of 33
GENERAL OPERATING INSTRUCTIONS
BEFORE OPERATING THE
MACHINE
Read the manual carefully and completely before
attempting to operate the unit. This manual has
important information for the use and safe operation
of the machine and should be kept available at all
times. This machine will ensure years of
satisfactory service if operated and maintained
according to recommendations in this manual. If
additional help or information is needed, please
contact your distributor or Prochem.
Prochem carpet soil extraction machines have been
designed with the operator in mind. Provided you
read the instructions relating to the care of your
machine and follow them carefully and take
advantage of the helpful hints and advice that we
have passed on, you will achieve excellent cleaning
results and very quickly pay for your investment. A
detailed operational guide is given in the following
sections, however, the following important points
must be emphasised.
FAILURE TO OBSERVE THESE
INSTRUCTIONS MAY SERIOUSLY
AFFECT THE PERFORMANCE OF
THE MACHINE AND INVALIDATE
THE WARRANTY
•
Connection instructions - The 220 - 240V AC
models have been fitted with the appropriate
EC type sealed power cable and 3 prong 13
amp plug for the UK market. Ensure the
machine is connected to a 13 amp socket
outlet having the same configuration as the
plug. No adapter should be used with this
machine. Any modification to the plug type may
be dangerous and will void the warranty.
•
This equipment is intended for commercial use
only.
•
The machine was designed for use on carpet
and upholstery extraction applications as per
instructions and recommendations written in
this manual. Any deviation from its proper use
or purpose and the consequential damage that
may occur is the sole responsibility of the end
user.
•
Disconnect the power cord from outlet before
servicing. Do not leave machine connected to
an electrical outlet when unattended.
•
Do not immerse or use this machine in
standing water. Such use may cause electric
shock.
•
This equipment is not designed to handle or
use combustible/volatile substances such as
gasoline or kerosene, in, on, or near the
machine. The use of such materials will cause
an extreme hazardous condition.
•
Use defoamer at all times to prevent damage to
the vacuum motor(s).
•
Do not use water in excess of 170°F (76°C).
•
To prevent seal damage and chemical build-up
to the pump system, run clean water through
the solution lines after each days use.
•
All repairs must be carried out by an authorised
Prochem distributor.
•
Repairs should only be carried out by a
qualified person.
•
Do not use replacement parts other than
genuine manufacturers parts as specified in the
parts list.
•
Do not use chemicals in the machine other
than those supplied or approved by Prochem
Europe limited.
•
Do not use the machine as a 'dry' vacuum.
Always pre-vacuum carpets thoroughly with a
separate 'dry' vacuum cleaner.
•
Keep the solution tank and filter clean. Always
use a clean bucket to fill the solution tank.
•
Clean the waste tank, vacuum filter and fall-out
tube daily.
Do not allow the vacuum shut-off
filter to clog and do not restrict the free
movement of the ball float (where fitted).
Empty recovery tank regularly during use, do
not wait for it to fill up and cut the vacuum
motor out.
•
Clean the drain valve regularly. Lubricate the
valve shaft, slide and PVC elbow connection
with suitable oil or maintenance spray. Do not
drain the waste tank completely until the end of
each job, as this will tend to clog the seal with
debris and sediment.
•
After use, flush through the pump, solution
lines and waste tank with at least two gallons of
hot water.
•
Do not allow the machine, hoses or tools to
freeze.
Freezing may seriously damage the
pump and fittings. Always drain solution and
store indoors when not in use. When in transit
during freezing weather, insulate and cover
machine, wand and hoses. To prevent hose
cuffs splitting in cold conditions, immerse them
in warm water before use.