Gaither GT4532, Instructions Manual

Page: 3 / 26

Safety Notice
1. Installation: please insert “A
、
B
、
C
“
airpipes into adaptors accordingly. Install the operation rod and
main body together with fixed axis of operation rod. Place the retaining ring in good order. Pull the
operation rod to three different directions: horizontal direction of operation rod & main body, direction
of 45 degrees, and direction of 90 degrees. (As for operation procedure, please see the label of <Air
hydraulic Jack installation instruction> which sticks on the operation rod.)
2. Make reasonable choice of clean and dry air pressure (Grease filter must be installed on the air
resource), its application scope should be 8-12 bar (The MAX. air pressure of safety valve is 10bar) and
within the rated air pressure scope to guarantee life.
3. Connect it with air pipe. (See picture A)
4. Place the air hydraulic jack on a stable, flat, resistant, dry surface without drains or holes when using. If
necessary, place a wood board under the air hydraulic jack to avoid any deflection. (Please carefully
read the label of <Warnings> which sticks on the operation rod.) .
5. When lifting, place some secured stands or solid supports on the suitable area under raised vehicle to
assure security.
6. Before lifting, please estimate the weight of vehicle to avoid overloaded. The life of Jack will be
affected strongly if it is overloaded.
7. When lifing, position the equipment under the strongest centre point of the vehicle. Do not position the
Jack near or allow it to hit any bolt.
8. When Jack is lifting or lowering, in order to protect the Jack and oil cylinder, Please take hold of the
handle of operation rod to use Jack.
9. The air hydraulic jack applies to 32# hydraulic oil. Make sure there is enough filtered & clean hydraulic
oil to support the jack, otherwise the jack is unable to reach it rated hoisting height. If it lacks of oil,
please screw off the bolt of oil tank’s filling opening and fill suitable amount of oil then screw on.
10. Don’t shake it sharply when using. To move the air hydraulic jack, please keep the wheels balanced
with the operation rod in intermediate position.
11. Don’t place the Jack upside down when using.
12. Please keep the equipment cleaned & out of the reach of children when it is not using.
13. It is natural & normal to appear a little bit of oil leaking when transporting, loading and using it in the
first time.
14. If oil volume is too much, the oil will be exhausted by the way of fog through suction pump. After the
extra oil exhausted and this appearance will disappear.
15. If the oil is overfilled, pls use the available way to make it less to return to normal volume.
2