Ensure faceplate
has been removed.
Swivel latch &
auxiliary bolts as
required.
Ensure cam
is at 12 o'clock
when installing
adaptor
Adaptor
retaining
lugs
*Hub locking cam
is 2 piece with lost
motion. Ensure cam
is at 12 o'clock when
installing. Cam must
fit within internal
faces of swinging
locking bar.
Dogleg bend must
face away from
cylinder surface.
HUB LOCKING
CAM*
LATCH
RETRACTION
CAM
HUB LOCKING
& LATCH
RETRACTION CAM
ADAPTOR
LOCKING
CAM
LATCH
HOLD BACK
CAM
Bent gear teeth
face away from
cylinder surface.
Cam
orientation
shown with
key removed
Cam orientation
shown with key
inserted & rotated
from 6 to 12 o'clock
for installation
into lock.
Ensure short leg
is engaged into
fixing hole on
adaptor.
6B.
FACE PLATE INSTALLATION
-Install face plate.
FOR LOCKS WITH SINGLE
OR DUAL CYLINDERS
-Insert cylinder/s
paying careful
attention to cam
orientation. (Refer
to cam orientation
chart below).
-Insert 'U' shaped
retaining pin until
it is flush behind
housing
-Secure face plate
using supplied
countersunk fixing
screws. Do not use
a power driver to
tighten screws.
Stripped or cross
threaded screw
holes are not
covered by
warranty.
6C.
SPINDLE INSTALLATION
(IF REQUIRED)
- Insert spindle as shown
- Install spindle spring on
round boss of spindle.
89.0
AB
DOOR FACES
CYLINDER
CUT TAIL PIECE
TO EDGE OF
SCREW HEAD
AS SHOWN
TURN
KNOB
89.0
AC
8.0
DOOR FACES
INDICATOR/
EMERGENCY
RELEASE
TURN
KNOB
CUT TAIL PIECE
AS SHOWN
FOR LOCKS WITH TURN
KNOB ADAPTORS
-Insert cylinder (if required)
on opposite side of adaptor.
Pay careful attention to cam
orientation. (Refer to cam
orientation chart below).
-Align 'J' shaped adaptor
retaining pin so that short
leg engages adaptor side.
The long leg engages
into the cylinder
(where fitted).
-Insert retaining
pin until it is flush
behind housing.
4.
INSTALLING TURN KNOB
ADAPTOR (IF REQUIRED)
3.
HANDING
BOLTS.
Always install turn knob adaptor on
the same side as the turn knob.
-Angle adaptor so that
retaining lugs hook
bottom of oval housing
slot.
-Rotate top of adaptor
so that face is flush with
housing.
6.
INSTALL CYLINDER/S & RETAINING PIN
5B
-Use supplied
screws to
secure lock
5A
- Fit lock
through slot.
5.
INSTALL
LOCK
8.
CUT TURN KNOB TAIL PIECE LENGTH (WHERE REQUIRED)
FOR TURN KNOBS USED
WITH AN INDICATOR/
EMERGENCY RELEASE
ON OPPOSITE SIDE
FOR TURN KNOBS USED
WITH A CYLINDER
ON OPPOSITE SIDE
7.
INSTALL FACE
PLATE & SPINDLES
CAM ORIENTATION CHART
