GAI-Tronics Titan GSM, Installation And User Manual

Page: 19 / 36

Titan GSM 19
4.10. Switch on and test
1. Once the SIM card has been fitted and DC power connected, press
and hold the red on/off button located next to the power connector.
The FUNCTION and ERROR indicators will both light and will then
go off, when this occurs release the button. The FUNCTION indicator
will flash rapidly to indicate that the phone is initialising and is
searching for a valid mobile network.
2. After several seconds, the FUNCTION indicator should flash less
frequently to indicate that a call may be made or received. If there is
an error, for example no SIM installed, the ERROR indicator will light.
See the table on the previous page for a full list of indicator
conditions.
3. Using a mobile phone, send an SMS status command to the phone
requesting the current status. Use the following format for your
outgoing message:
1234STAT
(where 1234 is the default PIN code.) The reply should be similar to
the following:
State: 14
Signal: -89dBm
Supply: 12.2V
Bat: 4.191V
Temperature
Now: 20
Min: 18
Max: 26
No fault
Ver: 1.3
4. If all is well with the status response, record the information for
reference, to compare with later status reports.
5. Refit the faceplate:
a. Open the spring loaded door of the pre-mounted rear enclosure
(where fitted), taking care not to trap fingers.
b. Carefully place the faceplate onto its mounting flange, taking care
not to trap any cables.
c. Insert the 4 fixing screws and use a 3mm hex key to tighten.
d. Check that a good weatherproof seal exists between the front and
rear casings.
6. Make a call to the phone to ensure the sounder operates. Then make
an outgoing call from the phone to an external number. This will only