GAI-Tronics Auteldac 4, Installation And User Manual

Page: 14 / 28

Auteldac 4 13
5. Re-tighten the straps firmly and trim off any excess band material.
For security the driving head of the band may also be sawn off.
2.6 Desk Mounting / Rake
IMPORTANT WARNING:- Risk of impact or falling
This telephone, when used in a desk mounting mode, should be located
on a horizontal, flat non-slip surface. Due to the heavy and robust
construction of the unit, users must take care when using the handset
or headset, not to pull the cord to such an extent as to cause the
telephone to be pulled off the flat surface, and possibly cause damage
or injury to persons or equipment. Therefore it is recommended that the
unit be fixed in position using fixing positions and method detailed in
section 2.4 if there is any risk of the unit being dislodged as described
above.
To provide a 'rake' for convenient operation, the Front Casing may be
turned through 180° before it is fitted to the Rear Casing. Thus the
cable entries are at the rear of the telephone.
1. Ensure that the supplied rubber feet are fitted to the underside of the
Rear Casing if the telephone if not fixed into position.
2. Rotate the Front Casing through180° and fold the keypad ribbon
cable to ensure that it lays flat against the potted block when re-
assembled. Refer to Figure 9 - Ribbon cable positions (page 21)
3. Continue the installation procedure with the connection of individual
wires from the cable as described in sections 2.7 onwards.
Figure 4 - Providing the rake