Gaggia Milano ANIMA FOCUS RI8760, Instruction Manual

Page: 26 / 84

20
ENGLISH
10.2.1 installation
>
Remove the small white filter in the water tank and store it in a dry place.
Filter setting phase
> Remove the water filter from its packaging, immerse it vertically in cold
water, with the opening upwards, and slightly press the sides to let air bubbles out.
In order to use the filter correctly, it is necessary to measure the water hardness as
shown in the “5.3.1 Water hardness measurement and setting” chapter.
>
Set the water filter according to the results of the test, operating on the
filter base:
Letter on the filter Water hardness Test strip squares
A soft water 1 - 2
B hard water (standard) 3
C very hard water 4
> Insert the water filter in the empty water tank.
>
Push it to the lowest possible point.
>
Fill the water tank with fresh water and restore it to the machine.
Dispense all the water contained in the tank as detailed in the “6.4.1 Hot water
dispensing” chapter.
>
Fill the water tank again.
Machine setting phase during the installation
>
Press the MENU button and scroll the menu to go to the ‘ Filter function.’
The default setting is OFF (inactive filter).
>
Press the UP button to select the ON value.
>
Press the OK button to confirm the change.
The modified but unconfirmed values will not be stored.
With the ON value the machine is programmed to inform the user that the
water filter must be replaced.
Once the filter has been activated, no icon appears on the
display.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3
minutes. At the end, the machine goes back to the main menu.
10.2.2 replacement
The ‘ water filter to be replaced’ signal is displayed.
Replace the water filter as described in the “10.2.1
installation” chapter, performing only the “Filter setting phase” section, and then
proceed as follows.
Machine setting phase during the replacement
> Press the MENU button and scroll the menu to go to the ‘ Filter function.’
The value is ON (active filter).
>
If you wish to replace the water filter with a new filter, press
the DOWN button until the RESET value can be selected. Alternatively, if you wish to
remove the filter without replacing it, select the OFF value.
>
Press the OK button to confirm the change.
The modified but unconfirmed values will not be stored.
Selecting RESET, the machine is programmed to manage a new water
filter, otherwise, selecting OFF, replace the supplied white filter in the tank.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3
minutes. At the end, the machine goes back to the main menu.
A B C
ON
OFF
FIL
TER
FIL
TER
ON
OFF
RESET
FIL
TER
ON
OFF
RESET
FIL
TER
A B C