en
Disposal
14
Fault
Cause and troubleshooting
The appliance does
not heat up. After the
appliance is switched
on, the illuminated
ring on the control
knob lights up white
for 10 seconds and
then the illuminated
ring on the active
control knob lights up
orange.
Demo mode is activated.
▶
There is a noise
when the appliance is
switched on. The illu-
minated ring around
the control knob
lights up green for a
few seconds and
then yellow.
Each time the mains power is switched on or following a power cut, the appliance starts up
the gas valves.
▶
Wait until the illuminated ring goes out.
11.2 Deactivating demo mode
If the illuminated ring on the control knob lights up
white for 10 seconds after the appliance is switched
on, demo mode is activated. The burner does not ig-
nite. The illuminated ring around the control knob lights
up orange.
1.
Turn the control knob to 0.
2.
Disconnect the appliance from mains power supply.
3.
Wait for 30 seconds.
4.
Reconnect the appliance.
a
The illuminated ring around the control knob lights
up green for a few seconds and then yellow.
5.
Wait until the illuminated ring goes out.
6.
Deactivate demo mode within the next 3 minutes.
While the control knob is pushed in, carry out the
following steps without interruption:
‒
Turn the control knob anti-clockwise to 12 .
‒
Turn the control knob clockwise to 1 .
‒
Turn the control knob anti-clockwise to 0 .
a
The illuminated ring on the control knob lights up
yellow.
7.
Turn the control knob clockwise to 1.
a
The illuminated ring on the control knob lights up
green.
8.
Wait approximately 5 seconds.
a
The illuminated ring on the control knob lights up
yellow.
a
Demo mode is now deactivated.
9.
Push the control knob in. While the control knob is
pushed in, carry out the following steps without in-
terruption:
‒
Turn two notches anti-clockwise to 0 .
‒
Turn the control knob one notch anti-clockwise to
12 .
‒
Turn the control knob three notches clockwise to
1 .
‒
Turn two notches anti-clockwise to 0 .
a
The appliance saves the changed settings.
a
The illuminated ring on the control knob goes out.
12 Disposal
12.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
