11
3
Turn the control knobs and the gas valves to the
zero position. Assemble the spindles between the
control knobs and the gas valves. Slide the rear
parts fully over the gas valve shafts. Fix the
spindles in place with the locking screws.
4
Connect the appliance to the mains and gas and
check that it is working. If the appliance switches
off, there may be air in the gas pipe. turn the
control knob to 0 and ignite again. Repeat the
operation until the appliance ignites.
5
Flush installation only: it is imperative to test
functioning before jointing!
Joint the surrounding
gap with a suitable, temperature-resistant silicone
adhesive (such as OTTOSEAL
®
S 70). Smoothen
the seal joint with smoothing agent recommended
by the manufacturer. Observe the notes on
processing the silicone adhesive. Do not operate
the appliance until the silicone adhesive has dried
completely (at least 24 hours, depending on room
temperature).
NOTICE:
Unsuitable silicone adhesive used on
natural stone worktops will cause permanent
discoloration.
Connect Gas Supply
The appliance is shipped from the factory for use with
natural gas. It must be converted for use with propane.
A qualified technician or installer must do the
conversion.
Before connecting the appliance, please check
whether the local connection conditions such as gas
type and gas pressure match the appliance settings.
Make sure the gas supply is turned off at the manual
shut-off valve before connecting the appliance.
The gas connection must be in a location that permits
access to the manual shut-off valve and which, if
applicable, is visible after opening the door of the
cabinet.
SERVICER INFO ONLY
Connect the gas supply using the ½" U.S.A. elbow
and the fiber gasket supplied with the unit. The
shorter, nontapered thread fits into the threaded nut
on the hob. The longer, tapered U.S.A. thread is for
the incoming gas supply. Vent the gas line, check for
leaks. The gas pressure regulator is supplied with the
unit and comes set for natural gas. To convert
regulator to LP (propane) gas:
Make-Maxitrol Model RV 47 CL ½ PSIG
1
Remove the aluminum cap from the top of the
regulator.
2
Remove the yellow plastic shaft from the cap by
pushing it sideways until it pops out of the groove
in the cap.
3
Turn the shaft over and push back into the cutout
in the cap.
4
Replace the cap on the regulator.
Connect Electrical Supply
Before connecting supply cord to wall receptacle,
make certain that gas shutoff valve and all burner
controls are in OFF position.
Electrical connection (AC 110-127 V) is established
by means of a connecting cord with a grounding
contact plug connected to a grounded socket, which
must also be accessible after installation of the gas
cooktop.
Burner Cap Placement
The burner parts must be properly placed for the
cooktop to function properly. If the burner parts are
not properly placed, one or more of the following
problems may occur:
▯
Burner flames are too high.
▯
Flames shoot out of burners.
▯
Burners do not ignite.
▯
Burner flames light unevenly.
▯
Burner emits gas odor.
Placing Burner Parts
After electrical connection is complete, assemble the
burner parts correctly and evenly. When assembling
the burner parts, make sure that the burner head is
placed on the base in such a way that the prongs of
the burner cap fit snugly into the groove of the burner
base.
D
E
F
