Gaggenau VG 414 210 CA, Use And Care Manual

Page: 16 / 52

16
Cleaning the appliance
Clean the appliance after each use, once it has
cooled down. Remove spilled fluids immediately; don't
let any food rests burn on.
Keep the ventilation openings under the pan support
clean. The ventilation openings must not be covered.
Thoroughly dry the burners after cleaning. Only turn
on the appliance once all parts are dry. Damp burner
parts could cause problems with ignition or an
unstable flame.
When assembling the burner parts, pay attention to
their correct positions (latching lugs). All parts must
lie flat.
Clean the electrode
A dirty electrode can disrupt ignition or flame
monitoring.
If required, clean it with the brush included. The
electrode is sensitive. Clean it carefully. Do not twist
or damage it.
Do not switch on the cooktop while
cleaning it.
Burned-on grime
For stubborn, burned-on grime, you can order a grille
cleaner gel from your specialist shop or our customer
service (order number 463582). It is suitable for pan
supports, burner parts and the stainless steel
cooktop. Leave on overnight if necessary. Bear in
mind the notes on the cleaner.
Burner discoloration
After prolonged use, the brass burner parts go dark
due to natural oxidation. The color changes has no
impact on useful benefit. Proceed as follows to
remove such discoloration:
1 Prepare a solution out of equal parts white
vinegar with no more than 8 % acid (domestic
vinegar) and warm water.
2 Place the discolored burner parts in the solution
for 10 minutes at most. Remove stubborn stains
with a cloth or a sponge.
3 Then thoroughly rinse the burner parts with clear
water and dry them well before their next use.
9
CAUTION
Too high a concentration of solution or
excessively prolonged contact of the burner
parts with vinegar will damage the surface.
Appliance part/
surface Recommended cleaning
Stainless steel
surfaces Apply dishwashing liquid – dry off with a
soft cloth. Only use a little water for
cleaning; no water must penetrate into
the appliance.
Soak burned-in grime in a little water and
some dishwashing liquid. Do not scrub it
off.
Use our stainless steel cleaner (order
number 311413) to remove extreme soil-
ing or yellow discoloration caused by
heat.
Pan supports Remove carefully for cleaning. Soak
them in the sink. Clean with a dishwash-
ing brush and dishwashing liquid.
Clean carefully around the rubber buf-
fers so they do not come loose.
Rinse them with clear water and carefully
dry them before putting them back in
place.
Do not wash them in a dishwasher!
Burner parts
(brass) Dishwashing liquid – dry with a soft
cloth. Make sure openings are not
clogged.
Make sure that no small parts are lost.
Do not wash them in a dishwasher!
Control knobs Dishwashing liquid – the cloth must not
be too moist. Wipe dry with a soft cloth.