45
Hood control
en
Connecting appliances via your home network
If the appliances are connected to each other via your
home network, both the hood controls and Home
Connect can be used to operate the hob.
Notes
–
Make sure you follow the safety instructions in the
instruction manual for your extractor hood and that
these are complied with even when operating the
appliance via the hood controls on the
hob.
"Important safety information" on page 5
–
If the appliance is being operated by means of the
controls on the extractor hood, this mode of
operation always has priority. It is not possible to
use the hood controls on the hob during this time.
–
In networked standby mode, your appliance
requires a maximum of 2 W.
Setting up
To set up the connection between the hob and cooker
hood, the hob must be switched on.
Connecting directly
Make sure that the extractor hood is switched off.
For more information refer to the section entitled
"Connecting to the hob" in the instruction manual for
your extractor hood.
Note:
If you connect your hob directly to the extractor
hood, it cannot be connected to your home network as
well and you will not be able to use Home Connect.
1
To open the basic settings, touch the
t
symbol on
the main screen.
2
Scroll left or right with your finger and select the
Hood control
setting
}
.
3
Select the
Hood control
option and then touch the
G
symbol to confirm your choice.
4
You have 2 minutes to initiate the connection
process on the extractor hood. See extractor hood
operating instructions.
Once the process is complete, a message will be
displayed, informing you of the result of the connection
process. If the connection has been successfully
established, the
S
symbol for ventilation control from
the hob will appear on the main screen.
If you wish to change the setting, select the
Hood
control
option
S
again and then change the setting as
required.
Connecting via your home network
You require a router that has WPS functionality.
Access to your router is required. If you do not have this,
follow the steps listed under "Direct connection".
When you begin, make sure that the extractor hood is
connected to the same home network.
1
To open the basic settings, touch the
t
symbol on
the main screen.
2
Scroll left or right with your finger and select the
Hood control
setting
}
.
3
Select the
Home network
option and then touch
the
G
symbol to confirm your choice.
4
Press the WPS button on the router within the next
2 minutes.
A message will be displayed to notify you when the
hob is successfully connected to your home
network.
5
You have 2 minutes to initiate the connection
process on the extractor hood. See extractor hood
operating instructions.
Once the process is complete, a message will be
displayed, informing you of the result of the connection
process. If the connection has been successfully
established, the
S
symbol for ventilation control from
the hob will appear on the main screen.
Note:
Connection can only be established when both
appliances are connected to your home network and the
connection process has been initiated for both of them.
If the time allowed for connecting has already expired
for one of the two appliances, initiate the connection
process again.
Disconnecting from the network
The connection to the home network can be deleted.
1
To open the basic settings, touch the
t
symbol on
the main screen.
2
Scroll left or right with your finger and select the
Hood control
setting
}
.
3
Select the
Disconnect Hood control
option
‡
and
then touch the
G
symbol to confirm your choice.
The connections have now been deleted.
Note:
The connection to the home network can be re-
established at any time.
Summary of Contents for CX 482
Page 1: ...Instruction manual CX 482 Full surface induction cooktop...
Page 55: ......
